This feature can be used to prevent, or even eliminate, the chance of a ride crash, either due to brake failures in the station or due to a train stalling out or not completing a circuit.

Rides running in Block Section Continuous Circuit Mode treat the first tile of the station and the last tile of any lift hill as a block brake by default. Rides operating in this mode may carry more trains than would fit in the station, since the station now only needs to be long enough to accommodate a single train.

The maximum number of trains on a ride with block brakes is one fewer than the number of block brakes on the ride (including the top of all lift hills and the station). Therefore, a ride running with one station and one lift hill in Block Section Continuous Circuit Mode could only run one train.īlock brake sections in all cases will slow a passing train down. If the section immediately following the brake is free of trains, the block brake will allow the train to pass, albeit at a very slow speed (~4 mph). If, however, the section following a brake is occupied by a train, the brake will hold the passing train in place until the section is cleared. The use of block brakes complicates the construction of rides. Timing the length of each ride section becomes crucial, to prevent trains from being held up at block brakes for too long. Preferably, a ride should be able to run a complete circuit without being stopped by a block brake, if the ride is well-designed and nothing has happened on the ride (such as a breakdown) to alter the timing of the ride.

THEME PARK TYCOON 2 SCRIPT FOR AXON FREE.

Theme park tycoon 2 script for axon